SPECIAL AMMUNITION FOR BLOWGUNS
The blowgun is an interesting weapon which has several advantages. A
blowgun can be extremely accurate, concealable, and deliver an explosive or
poisoned projectile. The manufacture of an explosive dart or projectile is
not difficult. To acquire a blowgun, please contact the editor at one of the
addresses given in the introduction.
Perhaps the most simple design for such involves the use of a pill capsule,
such as the kind that are taken for headaches or allergies. Empty gelatin pill
capsules can be purchased from most health-food stores. Next, the capsule
would be filled with an impact-sensitive explosive, such as mercury fulminate.
An additional high explosive charge could be placed behind the impact
sensitive explosive, if one of the larger capsules were used.
Finally, the explosive capsule would be reglued back together, and a tassel
or cotton would be glued to the end containing the high explosive, to insure
that the impact-detonating explosive struck the target first.
Such a device would probably be about 3/4 of an inch long, not including the
tassel or cotton, and look something like this:
____________________
/mercury | \-----------------------
(fulminate| R.D.X. )---------------------- } tassels
\________|___________/-----------------------
Care must be taken- if a powerful dart went off in the blowgun, you could
easily blow the back of your head off.
SPECIAL AMMUNITION FOR WRISTROCKETS AND SLINGSHOTS
A modern wristrocket is a formidable weapon. It can throw a shooter marble
about 500 ft. with reasonable accuracy. Inside of 200 ft., it could well be
lethal to a man or animal, if it struck in a vital area. Because of the
relatively large sized projectile that can be used in a wristrocket, the
wristrocket can be adapted to throw relatively powerful explosive projectiles.
A small segment of aluminum pipe could be made into an impact-detonating
device by filling it with an impact-sensitive explosive material.
Also, such a pipe could be filled with a low-order explosive, and fitted
with a fuse, which would be lit before the device was shot. One would have to
make sure that the fuse was of sufficient length to insure that the device did
not explode before it reached its intended target.
Finally, .22 caliber caps, such as the kind that are used in .22 caliber
blank guns, make excellent exploding ammunition for wristrockets, but they
must be used at a relatively close range, because of their light weight.
SPECIAL AMMUNITION FOR FIREARMS
When special ammunition is used in combination with the power and
rapidity of modern firearms, it becomes very easy to take on a small army with
a single weapon. It is possible to buy explosive ammunition, but that can be
difficult to do. Such ammunition can also be manufactured in the home. There
is, however, a risk involved with modifying any ammunition. If the ammunition
is modified incorrectly, in such a way that it makes the bullet even the
slightest bit wider, an explosion in the barrel of the weapon will occur. For
this reason, NOBODY SHOULD EVER ATTEMPT TO MANUFACTURE SUCH AMMUNITION.
SPECIAL AMMUNITION FOR HANDGUNS
If an individual wished to produce explosive ammunition for his/her
handgun, he/she could do it, provided that the person had an impact-sensitive
explosive and a few simple tools. One would first purchase all lead bullets,
and then make or acquire an impact-detonating explosive. By drilling a hole
in a lead bullet with a drill, a space could be created for the placement of
an explosive. After filling the hole with an explosive, it would be sealed in
the bullet with a drop of hot wax from a candle. A diagram of a completed
exploding bullet is shown below.
_o_ ------------ drop of wax
/|*|\
| |*|-|----------- impact-sensitive explosive
| |_| |
|_____|
This hollow space design also works for putting poison in bullets.
In many spy thrillers, an assassin is depicted as manufacturing
"exploding bullets" by placing a drop of mercury in the nose of a bullet.
Through experimentation it has been found that this will not work. Mercury
reacts with lead to form a inert silvery compound.
SPECIAL AMMUNITION FOR SHOTGUNS
Because of their large bore and high power, it is possible to create some
extremely powerful special ammunition for use in shotguns. If a shotgun shell
is opened at the top, and the shot removed, the shell can be re-closed. Then,
if one can find a very smooth, lightweight wooden dowel that is close to the
bore width of the shotgun, a person can make several types of shotgun-launched
weapons.
Insert the dowel in the barrel of the shotgun with the shell without the
shot in the firing chamber. Mark the dowel about six inches away from the end
of the barrel, and remove it from the barrel.
Next, decide what type of explosive or incendiary device is to be used.
This device can be a chemical fire bottle (sect. 3.43), a pipe bomb (sect
4.42), or a thermite bomb (sect 3.41 and 4.42). After the device is made, it
must be securely attached to the dowel. When this is done, place the dowel
back in the shotgun. The bomb or incendiary device should be on the end of the
dowel.
Make sure that the device has a long enough fuse, light the fuse, and fire
the shotgun. If the projectile is not too heavy, ranges of up to 300 ft are
possible. A diagram of a shotgun projectile is shown below:
____
|| |
|| |
|| | ----- bomb, securely taped to dowel
|| |
||__|
|| |
|| | ------- fuse
|| |
||
||
||
|| --------- dowel
||
||
||
|| --------- insert this end into shotgun
||
||
Special "grenade-launcher blanks" should be used- use of regular blank
ammunition may cause the device to land perilously close to the user.
SPECIAL AMMUNITION FOR COMPRESSED AIR/GAS WEAPONS
This section deals with the manufacture of special ammunition for
compressed air or compressed gas weapons, such as pump B.B guns, CO2 B.B guns,
and .22 cal pellet guns. These weapons, although usually thought of as kids
toys, can be made into rather dangerous weapons.
SPECIAL AMMUNITION FOR B.B GUNS
A B.B gun, for this manuscript, will be considered any type of rifle or
pistol that uses compressed air or CO2 gas to fire a projectile with a caliber
of .177, either B.B, or lead pellet. Such guns can have almost as high a
muzzle velocity as a bullet-firing rifle. Because of the speed at which a .177
caliber projectile flies, an impact detonating projectile can easily be made
that has a caliber of .177.
Most ammunition for guns of greater than .22 caliber use primers to
ignite the powder in the bullet. These primers can be bought at gun stores,
since many people like to reload their own bullets. Such primers detonate when
struck by the firing pin of a gun. They will also detonate if they are thrown
at a hard surface at a great speed.
Usually, they will also fit in the barrel of a .177 caliber gun. If they are
inserted flat end first, they will detonate when the gun is fired at a hard
surface. If such a primer is attached to a piece of thin metal tubing, such as
that used in an antenna, the tube can be filled with an explosive, be sealed,
and fired from a B.B gun. A diagram of such a projectile appears below:
_____ primers _______
| |
| |
| |
V V
______ ______
| ________________________ |-------------------
| ****** explosive ******* |------------------- } tassel or
| ________________________ |------------------- cotton
|_____ _____|-------------------
^
|
|
|_______ antenna tubing
The front primer is attached to the tubing with a drop of super glue. The
tubing is then filled with an explosive, and the rear primer is glued on.
Finally, a tassel, or a small piece of cotton is glued to the rear primer, to
insure that the projectile strikes on the front primer. The entire projectile
should be about 3/4 of an inch long.
SPECIAL AMMUNITION FOR .22 CALIBER PELLET GUNS
A .22 caliber pellet gun usually is equivalent to a .22 cal rifle, at
close ranges. Because of this, relatively large explosive projectiles can be
adapted for use with .22 caliber air rifles. A design similar to that used in
section 5.12 is suitable, since some capsules are about .22 caliber or
smaller. Or, a design similar to that in section 5.31 could be used, only one
would have to purchase black powder percussion caps, instead of ammunition
primers, since there are percussion caps that are about .22 caliber. A #11
cap is too small, but anything larger will do nicely.
-= Exodus =-